How to solve the UV flatbed printer print-in reset fault?
The faults of the UV flatbed printer reset are mainly concentrated in four aspects: the printing can be reset without response, the reset Z axis only rises or falls, the normal reset cannot be completed, and X always moves to the right during reset. The solution to each fault is different.
1.UV flatbed printer can reset the point and print without response
A. There is a problem with the computer system, the solution: computer system antivirus, and then restart;
B. The fiber cable is broken or loose. Solution: Tighten the fiber cable if it is loose, and replace it with a new fiber cable if it is broken.
2, UV flatbed printer reset Z axis only rise or fall
A. Z driver signal line is missing, solution: reconnect the Z driver signal line;
B. Missing item of motor power cable, solution: Reconnect the missing item of motor power cable;
C. the main board loss melding, the solution: re-weld the main board .
3, UV flat printer movement cannot be reset normally
A. Optical fiber communication failure, solution: replace the bad optical fiber;
B. The emergency stop switch is not turned on. The solution: just turn on the emergency stop light again;
C. Computer system fault, solution: anti-virus computer system, and then restart;
4.X moves to the right when UV flatbed printer resets
A. The Y-axis signal cable has poor contact. Solution: If the interface is loose, reconnect the Y-axis signal cable.
B. The round fiber optic cable is damaged, the solution is to replace the new round fiber optic cable;
C. Computer system fault, solution: anti-virus computer system, and then restart
