How to solve X carriage solution in UV flatbed printer stand-by ?
When something temporarily leaves for a short time and no longer operates, the UV flatbed printer is set to the standby state, and the x-axis and y-axis are also static. If the x-axis carriage movement is found, it means that the fiber cable is damaged or loose.
Solution: The optical fiber wire itself has a certain service life. The more intense and continuous printing is, the faster the abrasion will occur. Under normal circumstances, the fiber cable can be replaced with a new one within 6-8 months. If the equipment runs for more than 16 hours per day, it is recommended to replace it every 4 months. If the fiber cable is loose, re-tighten the fixed interfaces on both sides. If it is damaged and split, replace it with a new one.
have to be aware of is:
1. Don’t wait too long in the standby state of the UV flatbed printer. When in this state, you can turn on the flash spray moisturizing function of the nozzle to avoid the nozzle being blocked;
2. When the UV flatbed printer works for one day and needs to be turned off, it is necessary to turn off the power supply of the nozzle, water tank and equipment one by one, reset the equipment to its original point, and moisturize;
3. If the holiday time is more than 5 days, you need to disassemble, clean, seal and save the nozzle, remove the UV ink from the large ink cartridge, and clean the secondary ink cartridges and ink tubes. After they are all cleaned, take a layer The plastic protective film is covered on the UV flat printer body, and the dust proof treatment can be done.
